Acrylic & Fiberglass Bathtub Repair in Chicago
Cracks, chips, and wear — without replacing the tub
Acrylic and fiberglass tubs are everywhere in modern bathrooms, and over time they crack, chip, scratch, and dull. Replacement is expensive and, in most cases, unnecessary. We repair the damage and restore the surface with a pour-on coating that bonds to properly prepared acrylic and fiberglass — in one visit, in Chicago.
AFTER
BEFORE
Drag the handle — one visit, pour-on method
Free estimate
Get a price in a few hours
Leave your number — we’ll text back with a quote and open dates.
What we do
Repair and refinish in one system
For tubs made of acrylic, fiberglass, and plastic composites. We fix the damage first, then coat the whole surface so the repair disappears into a uniform finish.
- Repair chips, cracks, and minor structural damage
- Smooth scratched or worn areas
- Reinforce repaired spots before coating
- Apply a self-leveling pour-on coating for a clean, refreshed finish
What we fix on acrylic and fiberglass tubs
Each tub is evaluated individually — we confirm whether repair and coating are the right call before any work starts.
Chips and surface cracks
Filled, reinforced, and leveled before the coating goes on.
Burn marks and impact damage
Dropped objects, hot tools, curling irons — repaired and coated over.
Scratches and dull, worn areas
Smoothed and brought back to an even gloss.
Stains that won’t come out
Discoloration that survives every cleaner gets sealed under a fresh surface.
Visible previous repairs
Bad patches from earlier DIY or low-quality fixes — reworked and hidden under a uniform coat.
Overall surface wear
When the whole tub looks tired, the full pour-on coat resets it.
Tub typesWhat kind of bathtubs do we work with?
Refinish or replace?
Bathtub refinishing
- No demolition, no plumbing work
- 3–4 hours on site, one visit
- Ready to use in ~24 hours
- Bathroom stays usable during work
- Keeps your existing tile and fixtures
- Can be refinished again in 7–15 years
Bathtub replacement
- Tub removal, tile work, possible drywall
- Drain/overflow replacement, new fittings
- 2–5+ days of work
- Bathroom out of service the whole time
- Building permit and COI if plumbing moves
- Heavy cast iron to cut out and haul away
Pour-on coating for acrylic tubs
Instead of outdated reglazing or spray methods, we use a self-leveling pour-on coating that bonds to properly prepared acrylic and fiberglass, creates a uniform look after repairs, and — in most cases — removes the need to replace the tub.
When repair is the right call
- The tub structure is intact
- Damage is localized — chips, cracks, surface wear
- You want to avoid demolition and replacement
- You need a cost-effective restoration
With severe structural failure or extreme flexing, replacement may be the better option — we’ll say so.
What you avoid
- Demolition and tile removal
- The cost of a new tub and installation
- Days of downtime
- An old tub going to the landfill
Many tubs that look “beyond repair” come back with the right prep and coating.
Honest expectations: final results depend on the condition of the tub; repaired areas may not be identical to factory-new material; proper curing and aftercare matter for longevity; and not every tub is a candidate. We explain all of this clearly before starting any work.
@citytubFollow us on Instagram
Get a free acrylic tub repair quote in Chicago
Send a photo of your acrylic or fiberglass tub — we’ll tell you whether repair and pour-on coating are recommended, and what it will cost. Or call/text (312) 912-0000.